UTILIZATION OF ADC PIN ON ARDUINO NANO TO MEASURE VOLTAGE OF A BATTERY

##plugins.themes.academic_pro.article.main##

Muh Pauzan
Indri Yanti

##plugins.themes.academic_pro.article.details##

How to Cite
Pauzan, M., & Yanti, I. (2021). UTILIZATION OF ADC PIN ON ARDUINO NANO TO MEASURE VOLTAGE OF A BATTERY. TEKNOKOM, 4(2), 66–72. https://doi.org/10.31943/teknokom.v4i2.71

References

  1. Y. A. Mahardika, “Perancangan Alat Indikator Tegangan pada Sistem Pengisian Sepeda Motor,” 2017.
  2. M. Pauzan, “Rancangan Alat Indikator Level Tegangan Baterai Berbasis Operational Amplifier (Op Amp),” Teknokom, vol. 2, no. 1, pp. 11–16, 2019, doi: 10.31943/teknokom.v2i1.26.
  3. N. Yahya and A. Ihlas, “Pemantau Tegangan Baterai Ion Litium dalam Rangkaian Empat Seri pada Aplikasi Penyimpan Energi Berdaya Tinggi,” J. Pros. Semin. Nas. Tek. Kim., pp. 1–7, 2020.
  4. D. Satou, “Real-time Battery Cell Voltage Measurement Method Using LC Series Circuit Type Cell Voltage Equalizer,” 2019 IEEE 4th Int. Futur. Energy Electron. Conf. IFEEC 2019, vol. 2, no. c, pp. 1–4, 2019, doi: 10.1109/IFEEC47410.2019.9015080.
  5. M. Pauzan and I. Yanti, “Penggunaan Pin ADC ( Analog to Digital Converter ) pada Mikrokontroler ATmega8535 untuk Menghasilkan Catu Daya Digital,” ELKHA J. Tek. Elektro Untan, vol. 11, no. 2, pp. 122–127, 2019.
  6. M. Zlochisti, S. A. Zahrai, N. Le Dortz, and M. Onabajo, “Comparator design and calibration for flash ADCs within two-step ADC architectures,” Proc. - IEEE Int. Symp. Circuits Syst., vol. 2019-May, 2019, doi: 10.1109/ISCAS.2019.8702523.
  7. L. A. Garcia-Lugo, E. C. Becerra-Alvarez, J. Ceballos-Caceres, and J. M. De La Rosa, “Using Arduino and on-chip serial-to-parallel register to test widely-programmable ADCs,” 2016 Conf. Des. Circuits Integr. Syst. DCIS 2016 - Proc., pp. 125–128, 2017, doi: 10.1109/DCIS.2016.7845365.
  8. H. Wang, S. W. Sin, C. S. Lam, F. Maloberti, and R. P. Martins, “LDO-Free Power Management System: A 10-bit Pipelined ADC Directly Powered by Inductor-Based Boost Converter with Ripple Calibration,” IEEE Trans. Circuits Syst. I Regul. Pap., vol. 67, no. 12, pp. 4174–4186, 2020, doi: 10.1109/TCSI.2020.3025350.
  9. T. Du, H. Geng, Y. Sun, H. Lin, H. Lv, and L. Yu, “Design and implement of a low cost control system of active magnetic bearings using LabVIEW Interface for Arduino,” 2017 IEEE Int. Conf. Mechatronics Autom. ICMA 2017, pp. 1833–1837, 2017, doi: 10.1109/ICMA.2017.8016096.
  10. N. Scharich, B. Schniter, A. Herbert, and M. S. Islam, “Battery management system using Arduino,” 2017 IEEE Technol. Eng. Manag. Soc. Conf. TEMSCON 2017, pp. 384–387, 2017, doi: 10.1109/TEMSCON.2017.7998405.
  11. H. A. Dharmawan, A. P. W. Yudi, and C. S. Widodo, “Timing management for acquisitions of AC voltage and current signals using an AVR microcontroller based system,” Proc. - 2017 Int. Semin. Sensor, Instrumentation, Meas. Metrol. Innov. Adv. Compet. Nation, ISSIMM 2017, vol. 2017-Janua, pp. 1–4, 2017, doi: 10.1109/ISSIMM.2017.8124250.
  12. K. El Hammoumi, R. El Bachtiri, M. Boussetta, and M. Khanfara, “Arduino Based Platform for Managing a PV Battery Charge,” Proc. 2019 7th Int. Renew. Sustain. Energy Conf. IRSEC 2019, 2019, doi: 10.1109/IRSEC48032.2019.9078303.
  13. M. Senthilkumar, K. P. Suresh, T. Gunasekar, and C. Pazhanimuthu, “Efficient Battery Monitoring System for E-Vehicles,” 2021 7th Int. Conf. Adv. Comput. Commun. Syst. ICACCS 2021, pp. 833–836, 2021, doi: 10.1109/ICACCS51430.2021.9442038.
  14. U. Manual, “Arduino Nano V2.3 User Manual,” Arduino, pp. 1–5, 2008, [Online]. Available: https://www.arduino.cc/en/Main/ArduinoBoardUno.
  15. F. Reverter and M. Gasulla, “Experimental characterization of the energy consumption of adc embedded into microcontrollers operating in low power,” I2MTC 2019 - 2019 IEEE Int. Instrum. Meas. Technol. Conf. Proc., vol. 2019-May, pp. 1–5, 2019, doi: 10.1109/I2MTC.2019.8826815.